Friday, November 20, 2020

Beginning the Side Panels



 Joining the Plywood

Each side panel requires two sheets of plywood joined together end to end. That was all that was needed to build my first boat (Water Rat). Blobster requires 17 sheets of plywood.

Joining the panels

The bulkheads have all been finished. Storing is always a problem in a small shop.


Next Step:
Lay out the lines for cutting the side panels.
at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Atypical's Maiden Voyage

Maiden Voyage. It's a great day. I launched Atypical at Sardis Lake. Not much wind, but I was elated that it floated and there were no l...

  • Final Steps:
    I've been applying trim moldings around the front and rear doors to the cabin and painting and finishing the topsides.  Next Steps: I...
  • Atypical's Maiden Voyage
    Maiden Voyage. It's a great day. I launched Atypical at Sardis Lake. Not much wind, but I was elated that it floated and there were no l...
  • Raising the Sail
    Sail is Up I spent today setting up the mast, raising the sail, attaching the downhall and the mainsheet. I will have to do some adjusting a...