Monday, December 7, 2020

Bilge Panels

Cutting the Bilge Panels

After cutting out the bilge panels the only part of the hull remaining to be cut out is the bottom which consists of two layers of 3/8 inch plywood.

 Bilge Panels




Bulkheads and panels stored in limited space available awaiting assembly.




Next Step:


Apply epoxy to the bilge panels. Then mark and cut out the bottom panels.

at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Atypical's Maiden Voyage

Maiden Voyage. It's a great day. I launched Atypical at Sardis Lake. Not much wind, but I was elated that it floated and there were no l...

  • Final Steps:
    I've been applying trim moldings around the front and rear doors to the cabin and painting and finishing the topsides.  Next Steps: I...
  • Atypical's Maiden Voyage
    Maiden Voyage. It's a great day. I launched Atypical at Sardis Lake. Not much wind, but I was elated that it floated and there were no l...
  • Raising the Sail
    Sail is Up I spent today setting up the mast, raising the sail, attaching the downhall and the mainsheet. I will have to do some adjusting a...