Tuesday, April 13, 2021

All Hull Panels Installed

Outer Bottom Panel Installed

With the installation of the outer bottom panel, the hull is complete. Of course there is much sanding, filling, and painting to be done before the hull is turned over. Of the 17 sheets of plywood only one 1/4 inch sheet remains for the cabin top. 




 Next Steps

Taper the edge of the bottom panel, tape and fill with epoxy. Then fiberglass the bottom.

at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Atypical's Maiden Voyage

Maiden Voyage. It's a great day. I launched Atypical at Sardis Lake. Not much wind, but I was elated that it floated and there were no l...

  • Final Steps:
    I've been applying trim moldings around the front and rear doors to the cabin and painting and finishing the topsides.  Next Steps: I...
  • Atypical's Maiden Voyage
    Maiden Voyage. It's a great day. I launched Atypical at Sardis Lake. Not much wind, but I was elated that it floated and there were no l...
  • Raising the Sail
    Sail is Up I spent today setting up the mast, raising the sail, attaching the downhall and the mainsheet. I will have to do some adjusting a...