Friday, July 16, 2021

Taping Inside Joints

 Taping Inside the Hull

Now that the hull has been turned over I have been filling and taping the interior surfaces of the plywood joints with two layers of fiberglass tape. It's not a fun job but a very important one. I'll be glad to get started on the interior carpentry.





Next steps:

Apply coats of epoxy to interior surfaces, prime interior surfaces, finish sanding, priming, and painting exterior topsides.

at

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

Atypical's Maiden Voyage

Maiden Voyage. It's a great day. I launched Atypical at Sardis Lake. Not much wind, but I was elated that it floated and there were no l...

  • Final Steps:
    I've been applying trim moldings around the front and rear doors to the cabin and painting and finishing the topsides.  Next Steps: I...
  • Atypical's Maiden Voyage
    Maiden Voyage. It's a great day. I launched Atypical at Sardis Lake. Not much wind, but I was elated that it floated and there were no l...
  • Raising the Sail
    Sail is Up I spent today setting up the mast, raising the sail, attaching the downhall and the mainsheet. I will have to do some adjusting a...